Creative Hardware

He Turned a Dead LG Phone's Own Radio Into a Shortwave Receiver — Using Its Bluetooth Chip as the Tuner

Logan Zarov's D325F-SDR project already repurposed an old phone's cellular modem as a software-defined radio. His newest trick reroutes the same phone's Bluetooth radio to work as a local oscillator, pulling the receive range down from gigahertz into shortwave.

The cheapest software-defined radio you can build might already be in a drawer: a dead Android phone. Maker Logan Zarov has spent the past stretch proving that a phone’s own cellular modem — the chip meant for talking to cell towers — can be coaxed into giving up its raw baseband data stream, turning it into a general-purpose receiver. His latest extension of that project, covered by Hackaday on November 9, pushes the trick further by recruiting a second radio inside the same phone to do something it was never designed for.

The original hack: a modem as a receiver

The base project, D325F-SDR, turns the cellular modem in an old LG D325 (L70 Dual) Android phone into an SDR. It requires rooting the phone and running LineageOS with a custom kernel and a modified modem firmware, plus wiring the modem’s RF bypass pins out to the phone’s own headphone jack through a homemade adapter — the antenna input. An Android app, based on Dennis Mantz’s RF Analyzer, then shows a live spectrum and waterfall and demodulates AM, FM, SSB, and CW directly on the phone. Zarov has used it to pull in FM broadcast stations, an analog TV carrier, and shortwave AM.

The new trick: Bluetooth as a local oscillator

A cellular modem’s native tuning range sits in the GHz band — useful for a lot of things, but not shortwave, which lives down in the single-digit MHz range. Zarov’s newest modification gets there by keying the phone’s Bluetooth transmitter to produce a steady carrier in the 2.4 GHz ISM band, then using that carrier as a mixer to shift the modem’s tuning range down into shortwave territory — the same basic principle a conventional superheterodyne receiver uses a local oscillator for, except here the “oscillator” is a stock Bluetooth radio being operated completely outside its intended function. It’s a genuinely clever repurposing: two separate radio subsystems on the same board, neither built for this, combined to do a job neither could do alone.

Hackaday’s write-up is blunt about what this is: “hackery at its most epic.” It’s also a direct continuation of a broader trend the outlet has been tracking — common, cheap radio chips in Wi-Fi interfaces, microcontrollers, and LoRa modules turning out to expose their baseband data streams if you look hard enough, each one a free SDR hiding inside hardware bought for something else entirely.